Settings |
(Seconds) | |
() | |
Apply Settings |
Idx | Name | Enabled | Type | Address | Port | Data Timeout |
---|
Update Delete |
: | |
|
() | |
() |
|
|
|
|
(etc. /dev/i2c-1, or empty for autodetection) |
(decimal value) |
()
Make sure the correct pin status is read by introducing a bounce delay. |
|
()
Maximum of one interrupt per pin allowed in this period (prevents interrupt storms). |
|
Auto configure devices: | |
For DAEnetIP2 boards password field must contain username:password. Example admin:admin |
CRC message validation: |
Using CRC message validation prevents incorrect data from entering the Domoticz database. |
Seconds
This limits the amount of meter updates. |
Poll inputs: | |
Poll relays: | |
Poll interval: | Seconds |
Auto Discovery: | |
Alarm Inputs: | |
eHousePRO Enable: | |
|
() | |
(%) | |
|
|
|
Change only to select another Toon when having multiple agreements |
() | |
(). | |
Two interval types need to be specified:
|
|
If not allowed, the car will not be woken up when polled for status information to avoid battery drain. Exceptions:
|
(Seconds) | |
Leave the username empty and press the LINK button on the Philips Hue bridge. Then press the 'Register on Bridge' button. |
|
Register on Bridge |
You need to sign up at Honeywell to get the API key and secret. Please follow the instructions on domoticz.com/wiki/HoneywellDeveloperApiKey |
If 'False' this will cause the MQTT message to be echoed back. In most cases this is a bad scenario and should be avoided. |
|
Select the Topic('s) Domoticz will use to publish outgoing messages. Flat - publish outgoing messagen on topic domoticz/out. Hierarchical - publish outgoing messagen on topic domoticz/out/${floorplan name}/${plan name}. Combined - Use both Flat and Hierarchical topic schemes. None - disable outgoing messages. Note that Hierarchical only reports sensor updates for sensors that are placed on a floorplan/plan. |
|
Add extra parameteres to rtl_433 command line. You may for instance :
|
If 'False' this will cause the MQTT message to be echoed back. In most cases this is a bad scenario and should be avoided. |
Select the Topic mode that Domoticz uses to send and receive messages.
|
← | |
← | |
(Seconds) This sets the interval between status requests. If you set this to less than 60 seconds you may be in violation of Honeywell's usage terms and have your account suspended! |
|
Synchronize installation: |
When enabled this will automatically register and keep your zone names in sync with the Evohome controller. |
Show schedule: |
When enabled this will show the next scheduled switch point when in Auto (FollowSchedule) mode. |
Show location: |
(implies synchronize installation) |
,
,
(keep at [0,0,0] if you only have one Evohome installation) |
|